|
|
|
 |
INCLUDES:
Controller, flow cell with flow switch,
probes, 3/8” tubing, fittings.
| |
pH |
ORP |
Feed Cycle |
| • Factory Setting: |
7.4 |
650 mV |
.6 sec. |
| • Display Range: |
6.8 – 8.2 |
0 – 995 mV |
| • Setpoint Range: |
7.0 – 8.0 |
400 – 900 mV |
| • Feed Cycles: |
.6 to 900 sec with 5-minute analyzation periods |
| • Power: |
120V corded |
| • Feed: |
Automatic or manual |
| • Maximum Amps: |
5 Amps |
| • Probes: |
One-year limited warranty |
| • Controller: |
One-year limited warranty on electronics |
|
|
|
• Digital readouts
• ORP technology
• Redox sensor
• Proportional feed or continuous feed
• Dip switch programmable settings |
• Flow switch included
• Lockout security feature
• Built-in out-of-range safety timeouts
• pH calibration
• Acid or base feed |
• Microprocessor logic
• Globe flow cell with flow switch
• Compatible with most peristaltic pumps
• Can also be used with erosion feeder/solenoid applications
• Manufactured in the USA |
|
|
Designed for optimal pH control where a Chlorine
Generator (Salt System) is installed.
INCLUDES: Controller, flow cell with flow switch, pH probe, 3/8" tubing and fittings.
- NOTE: It is recommended that an in-line filter system (part number 550591) be used before the flow cell.
|
|
|
- pH Monitoring from 6.8 pH to 8.2 pH
with .1 pH Resolution
- Set Level from 7.0 pH to 8.0 pH
- Dosing Options from Continuous to up to 15 Minutes
- Factory Set 5 Minute Delay in Timed Feed Mode
|
- Factory Set High (8.0 pH) and Low (7.0 pH) Alert Levels
- Single Button Calibration
- Overfeed Alert after 30 Minutes in Continuous
Feed and 30 Feed Cycles in Timed Feed Mode
(Requires Hard Reset)
- Easy to Read, Sun-Bright LED Display
|
- Configure for Acid or Base (Jumper)
- Compact Package (Approx. 7” x 5” x 3”)
- Configured for 120 VAC (Input/Output)
- Flow Switch Compatible
- Bright LED Indicators for Feed, Alert and Flow
- Manufactured in the USA
|
|
|
|
